Weak GPS and difficult to map

If the mower is difficult to map due to the weak GPS signal, please follow these instructions

1.Please put the GNSS Antenna and Charging Station according to the article below.

How to find suitable place for charging station and the GNSS antenna

Notes on replacing the charging station and GNSS antenna

★It is not recommended to place the charging station under a sheltered roof as this can cause GPS errors. (If there is no suitable place, move the charging station out of the shelter）

★Charging station and GNSS antenna must be placed away from glass, water, which can reflect the GPS signal propagation

2.How to map with the Start button

How to map your garden (v5.5.6/v0.3.6)

3. If step 1 and step 2 are correct and the problem persists, please move the mower to an open area, switch the mower off and on at the bottom and try again. 

4.If the mower still can not be used to map for the weak GPS, please operate as below

1.Please move the antenna to a more open location, delete the units and re-add them back to the App How to disconnect Novabot from your APP

2.Control the mower to walk around the antenna for about 10 metres and then go into map-making mode.

5. Please check the RTK cable connection if there is anything wrong with the cable. (Picture is necessary)

The problem was caused by an unstable GPS signal, which will continue to be monitored and we will do our best to reduce the frequency of the problem. Please contact [e-mail] for the problem you are experiencing, photo or video is necessary, thanks in advance for your cooperation.